I plan on 3D printing one nozzle and making a silicone mold to resin cast.
Is there any other interest?




Here's my 2 cents on the list,pizzaguy wrote:What off Erwan's list has the most interest? I'm going to take the ejection seat and cockpit set off the list. My 3D skills are no where near the level to do that.
LANTIRN pod
TARPS pod
GBU 24 AB
GBU 12
Mk 82 bombs
AN/ALQ-167(V) ECM pod
Early style Sidewinder missile rail
Early style gun gas vent
Agree, it does look good !bobb428 wrote:Looks great!
Steve,A-10LOADER wrote:Here's my 2 cents on the list,pizzaguy wrote:What off Erwan's list has the most interest? I'm going to take the ejection seat and cockpit set off the list. My 3D skills are no where near the level to do that.
LANTIRN pod
TARPS pod
GBU 24 AB
GBU 12
Mk 82 bombs
AN/ALQ-167(V) ECM pod
Early style Sidewinder missile rail
Early style gun gas vent
LANTIRN pod, yes. This can be used for other airframes : AV-8B, F-16 (pylon needed though )
TARPS pod, no. 162692 ( VF-84 jet ) was not wired to carry a TARPS pod.
GBU-24, maybe but, not for the Tomcat. The VF-84 version NEVER flew them and the VF-154 jet comes with them. Only problem is the 154 jet only has forward pallets and bomb racks so, you can only load one GBU-24 because in real life they were physically too big to load side by side. They had to be loaded diagonally so, one in the front and one on the opposite side in the back. This would have worked if JSI did the 4 pallets, like the 84 version, with bomb racks but, sadly they did not.
You could use the 24's for your F-16 or F/A-18 however.
GBU-12's, yes. These can be used for other airframes as well.
AN/ALQ-167(V) ECM pod, maybe, this could be useful for your F-16 if you want an Aggressor version.
Early side winder missile rail, up to you.
Early style gun vent, no, not unless you want to do a lot of modifications to your Tomcat.
Steve