First you need to pop off the old side tool boxes. This is not that hard to do and can be done with a flat screw driver.
You need to make a horizontal cut under the rear door just where the side start to flair out .
Then make a vertical cut just behind the last side tool box alignment peg socket . Both sides .
Now do you see the top Hanomag ( original) from the point of the muffler well ( front ) to the point were the armor sides come to a point ( back ) . Cut the armor side off so that it looks like the bottom Hano.
Now unscrew the 2 screws located under the front bumper and pop off the top half .
By cutting the side armor off it will expose the under frame so you need to use the 2 filler pieces ( in white ) to fill this void. These will be supplied in the kit .
You need to cut , fill, sand and paint all of this area under the body before you glue the new rear clamb shell piece . The new end piece is a single piece and the Hano's body is 2 pieces top and bottom. One you graft the new clam shell piece on there will be no separating the top and bottom hulls again.
More to fallow .
