Battleground Toys 1:18 - Flak 38 & Sd.Ah 51 - New photos
- grunt1
- Officer - Brigadier General
- Posts: 2979
- Joined: Tue Jul 25, 2006 8:41 pm
- Location: Indiana
- Contact:
Battleground Toys 1:18 - Flak 38 & Sd.Ah 51 - New photos
Here by popular request is the gun made most famous in Saving Private Ryan, the Flak 38 with Sonderanhanger 51 trailer.
Flak 38
- 3 Parts (Gun, body, platform)
- 100% glueless (snap) assembly
- Gun elevates
- Gun platform rotates 360 degrees
- Shield can be removed for Saving Private Ryan look
Sonderanhanger 51 trailer
- 3 Parts (2x wheels, trailer)
- 100% glueless (snap) assembly
- Trailer wheels roll
- Flak 38 gun platform snaps onto and off of trailer as desired
Ammunition kit included
- 5 Magazines
- 2 Ammo boxes
- 20 individual rounds
- 2 Magazines fit into each ammo box
- Magazines fit into Flak 38 gun breech
- Flak storage bracket holds up to 3 magazines
I'm going to paint her up over the next several days and will post finished shots when done.
----
Assembly instructions - Flak 38
----
Push gun brackets out slightly and "pop" round gun rails into corresponding round brackets on gun mount.
Gun will now elevate
Place mounted gun and chassis into gun platform by inserting large disk on the bottom into the large hole in the gun platform. Gun chassis will now rotate 360 degrees on platform.
Flak 38
- 3 Parts (Gun, body, platform)
- 100% glueless (snap) assembly
- Gun elevates
- Gun platform rotates 360 degrees
- Shield can be removed for Saving Private Ryan look
Sonderanhanger 51 trailer
- 3 Parts (2x wheels, trailer)
- 100% glueless (snap) assembly
- Trailer wheels roll
- Flak 38 gun platform snaps onto and off of trailer as desired
Ammunition kit included
- 5 Magazines
- 2 Ammo boxes
- 20 individual rounds
- 2 Magazines fit into each ammo box
- Magazines fit into Flak 38 gun breech
- Flak storage bracket holds up to 3 magazines
I'm going to paint her up over the next several days and will post finished shots when done.
----
Assembly instructions - Flak 38
----
Push gun brackets out slightly and "pop" round gun rails into corresponding round brackets on gun mount.
Gun will now elevate
Place mounted gun and chassis into gun platform by inserting large disk on the bottom into the large hole in the gun platform. Gun chassis will now rotate 360 degrees on platform.
Last edited by grunt1 on Wed Sep 05, 2012 5:38 pm, edited 8 times in total.
- grunt1
- Officer - Brigadier General
- Posts: 2979
- Joined: Tue Jul 25, 2006 8:41 pm
- Location: Indiana
- Contact:
Re: Battleground Toys 1:18 - Flak 38 & Sonderanhanger 51 Tra
Ammunition kit (included)
Magazines (3) fit into magazine storage bracket on gun
Magazines fit into gun breech
Ready for some action!
2 Magazines fit into each ammunition box
Magazines (3) fit into magazine storage bracket on gun
Magazines fit into gun breech
Ready for some action!
2 Magazines fit into each ammunition box
Last edited by grunt1 on Mon Aug 06, 2012 7:30 pm, edited 2 times in total.
-
- Officer - Brigadier General
- Posts: 9653
- Joined: Mon Jan 22, 2007 5:52 am
- Location: New Orleans
Re: Battleground Toys 1:18 - Flak 38 & Sonderanhanger 51 Tra
Yes yes yes !!!!!!!!!!!!!!!!!!
- grunt1
- Officer - Brigadier General
- Posts: 2979
- Joined: Tue Jul 25, 2006 8:41 pm
- Location: Indiana
- Contact:
Re: Battleground Toys 1:18 - Flak 38 & Sonderanhanger 51 Tra
Trailer assembly instructions:
Re: Battleground Toys 1:18 - Flak 38 & Sonderanhanger 51 Tra
hey just like in Saving Private Ryan. That is cool!
i never met an airplane i didn't like...
- grunt1
- Officer - Brigadier General
- Posts: 2979
- Joined: Tue Jul 25, 2006 8:41 pm
- Location: Indiana
- Contact:
Re: Battleground Toys 1:18 - Flak 38 & Sonderanhanger 51 Tra
Oh and of course... available now!
http://www.shapeways.com/model/637708/f ... -1-18.html
http://www.shapeways.com/model/637708/f ... -1-18.html
Re: Battleground Toys 1:18 - Flak 38 & Sonderanhanger 51 Tra
Hey Grunt1,
is there any chance you could a purchase of just the weapons in these types of kits for customs? I would love to just get the flak 38 gun and the nebelwerfer launcher, not the trailers and mounts, etc for customs. Is something like that feasible?
is there any chance you could a purchase of just the weapons in these types of kits for customs? I would love to just get the flak 38 gun and the nebelwerfer launcher, not the trailers and mounts, etc for customs. Is something like that feasible?
Best,
-Paul
-Paul
-
- Officer - Brigadier General
- Posts: 2124
- Joined: Mon Dec 13, 2010 1:46 am
- Location: California
- Contact:
Re: Battleground Toys 1:18 - Flak 38 & Sonderanhanger 51 Tra
I had a similar question about the Pak 36 and mounting it on a sdkfz 251paulpratt wrote:Hey Grunt1,
is there any chance you could a purchase of just the weapons in these types of kits for customs? I would love to just get the flak 38 gun and the nebelwerfer launcher, not the trailers and mounts, etc for customs. Is something like that feasible?
Re: Battleground Toys 1:18 - Flak 38 & Sonderanhanger 51 Tra
Amazing. Now if I can just find a German flatbed truck to mount the gun on. The Indy Jones truck might work.
Hmmmmnnn?
Hmmmmnnn?
Achtung! Spitfire!
Re: Battleground Toys 1:18 - Flak 38 & Sonderanhanger 51 Tra
you know, i thought of doing that but all the trucks used as mounts seem to have been single axle not double axle like the Indy truck
i never met an airplane i didn't like...
-
- Officer - Brigadier General
- Posts: 9653
- Joined: Mon Jan 22, 2007 5:52 am
- Location: New Orleans
Re: Battleground Toys 1:18 - Flak 38 & Sonderanhanger 51 Tra
This will mount on the Sdkfz 251 and the Panzer IV
Re: Battleground Toys 1:18 - Flak 38 & Sonderanhanger 51 Tra
panzer iv?
i never met an airplane i didn't like...
-
- Officer - Brigadier General
- Posts: 2124
- Joined: Mon Dec 13, 2010 1:46 am
- Location: California
- Contact:
Re: Battleground Toys 1:18 - Flak 38 & Sonderanhanger 51 Tra
It was mounted into the Krupp Protzeaferguson wrote:you know, i thought of doing that but all the trucks used as mounts seem to have been single axle not double axle like the Indy truck
Grunt can you make a Horch???
Re: Battleground Toys 1:18 - Flak 38 & Sonderanhanger 51 Tra
Flak panzer IV Mobelwagen. Pz IV chassis with four slab armoured sides that folded down, with the gun mounted in the centre, if memory serves me correct. Got to check if the gun is the same, though. The four- barrel flak gun was also used. And they even had an 88mm gun in a similar configuration. As for the Indy truck, I might try that as a WHAT IF. Doubt if I can find a more proper truck in this scale. And for the 251, it would need a modified rear end, but I am sure PH can fashion one with enough references. A future project, maybe?
Achtung! Spitfire!
-
- Officer - Brigadier General
- Posts: 2124
- Joined: Mon Dec 13, 2010 1:46 am
- Location: California
- Contact:
Re: Battleground Toys 1:18 - Flak 38 & Sonderanhanger 51 Tra
I think all Mk IV flak conversions used the single 37mm or the quad 20mm but yes they did make a few using the 88mm
-
- Officer - Brigadier General
- Posts: 2124
- Joined: Mon Dec 13, 2010 1:46 am
- Location: California
- Contact:
Re: Battleground Toys 1:18 - Flak 38 & Sonderanhanger 51 Tra
Here is the one in saving private ryan,
http://www.sproe.com/f/flak38.html
Notice the armor plate is gone
http://www.sproe.com/f/flak38.html
Notice the armor plate is gone
Re: Battleground Toys 1:18 - Flak 38 & Sonderanhanger 51 Tra
note the one in SPR has no shield...which looks cool.
the Panzer iv never carried just a single 20mm, to my knowledge. The Mobelwagen prototype mounted a flakvierling, but was never put into production that way. The standard mobelwagen mounted the much larger 37mm aa gun (another good project for somebody ).
the Panzer iv never carried just a single 20mm, to my knowledge. The Mobelwagen prototype mounted a flakvierling, but was never put into production that way. The standard mobelwagen mounted the much larger 37mm aa gun (another good project for somebody ).
i never met an airplane i didn't like...
- grunt1
- Officer - Brigadier General
- Posts: 2979
- Joined: Tue Jul 25, 2006 8:41 pm
- Location: Indiana
- Contact:
Re: Battleground Toys 1:18 - Flak 38 & Sd.Ah 51 - Painted
This model came out so well I couldn't resist putting it together and painting it... As a bonus, 21st Century figures fit perfectly!
I just realized the seatback is missing. It does come with the model so I must have lost it.
I just realized the seatback is missing. It does come with the model so I must have lost it.
Re: Battleground Toys 1:18 - Flak 38 & Sd.Ah 51 Trailer -Pai
You're right Aferg and JNewboy. Grunt1, it looks really neat all painted up.
Achtung! Spitfire!
Re: Battleground Toys 1:18 - Flak 38 & Sd.Ah 51 Trailer -Pai
Grunt1 great job
-
- Officer - Brigadier General
- Posts: 6028
- Joined: Mon Oct 04, 2004 6:30 pm
- Location: Atlantic Coast
Re: Battleground Toys 1:18 - Flak 38 & Sd.Ah 51 Trailer -Pai
Grunt, another outstanding piece! Looks Great!!!
- grunt1
- Officer - Brigadier General
- Posts: 2979
- Joined: Tue Jul 25, 2006 8:41 pm
- Location: Indiana
- Contact:
Re: Battleground Toys 1:18 - Flak 38 & Sd.Ah 51 Trailer -Pai
Thanks guys I need to put the wire basket on. Any thoughts on whether the gun and/or barrel should be metallic colored versus camouflaged? The restored ones are almost always a blued gunmetal and it's hard to tell from the B&W photos if that was the norm or always the case.
Here is what appears to be an original with the barrel painted, but the muzzle clean but weathered metal.
Here is what appears to be an original with the barrel painted, but the muzzle clean but weathered metal.
- grunt1
- Officer - Brigadier General
- Posts: 2979
- Joined: Tue Jul 25, 2006 8:41 pm
- Location: Indiana
- Contact:
Re: Battleground Toys 1:18 - Flak 38 & Sd.Ah 51 Trailer -Pai
Oh and sorry Paul, I missed your post. It depends on what you want. I plan on splitting the trailer from the Flak to keep the price down for those that just need the gun. That will be the standard offering in the future.
As for splitting the platform from the gun as a one off, I'll see what I can do.
I've got to balance the custom requests (there are several others) with time spent on new models, finishing up ones that are half-complete like the Schwimmer, Puma, LeiG and tweaking existing ones like the no-Panzerfaust scout bike, re-scaling the Goliaths, etc..
As for splitting the platform from the gun as a one off, I'll see what I can do.
I've got to balance the custom requests (there are several others) with time spent on new models, finishing up ones that are half-complete like the Schwimmer, Puma, LeiG and tweaking existing ones like the no-Panzerfaust scout bike, re-scaling the Goliaths, etc..