The Chopper II

pickelhaube · Post by **pickelhaube** » Sat Mar 28, 2009 5:52 pm

The Chopper II.

This is a dream come true customizing tool. I held off a while getting one but finally got it. You use it for repetative cutting of styreen and thin wood.

Although I cut myself 2 time while handeling it

, it sure is a time saver.

It is a little pricy but I sure wish I got one years ago.

Here is what it looks like.

Here is my thumb with shop first aid. Paper towls and masking tape.

flyboy_fx · Post by **flyboy_fx** » Sat Mar 28, 2009 7:59 pm

IF THEY MADE IT ANY BIGGER "caution sharp blade" it would bite you!
Ohh never mind

smittyrob64 · Post by **smittyrob64** » Sun Mar 29, 2009 12:15 pm

I've seen this at Micro-Mark but never knew if it was any good.
So apart from being good at thumb cutting, it works pretty well?

blaster_e11 · Post by **blaster_e11** » Mon Mar 30, 2009 12:29 am

cool tool

watch your finger while using it

pickelhaube · Post by **pickelhaube** » Mon Mar 30, 2009 6:24 am

smittyrob64 wrote:I've seen this at Micro-Mark but never knew if it was any good.
So apart from being good at thumb cutting, it works pretty well?

Yes it works real well. I would say it saved me about an hour the first time I used it. Of course it cost me about 15 mins. of badaging after cutting myself twice.