Question for the RC memebers.

hotrodrock · Post by **hotrodrock** » Mon Nov 17, 2008 12:20 pm

Is the bottom half of the Heng Long Panther the same as the Heng Long Tiger? There is an RC site that sells custom painted top halves of the Tiger at a decent price. I have one of HL's god awful Panthers and would like to just swap out the tops if the bottoms are the same. There is a difference in the rear piece that has the exhaust but I can get around that. Not worried about the innards, will use it as a static model only.

smittyrob64 · Post by **smittyrob64** » Mon Nov 17, 2008 2:49 pm

I don't have a HL pantiger, but I'm pretty sure the lower hulls are the same. The rear exhaust area is a plate that slides out of 2 slots on each side so if you got the rear plate from a tiger it should just slide into the pantigers lower hull.

MG-42 · Post by **MG-42** » Mon Nov 17, 2008 6:41 pm

*%+!#^@&$

hotrodrock · Post by **hotrodrock** » Mon Nov 17, 2008 9:49 pm

MG-42 wrote:*%+!#^@&$

Are you sure? I was thinking more along the lines of (*&^%$!

Small Scale Military Headquarters