Page 1 of 1
black hawk crew mac farlane
Posted: Thu Feb 22, 2007 3:06 pm
by supersonicfifi
do you think theses figures are compatible with our 1:18 helicopter ? i was thinking of using the head + helmet :
http://www.amazon.com/exec/obidos/tg/de ... 8&v=glance
thanx for your advices....
Philippe
Posted: Thu Feb 22, 2007 3:27 pm
by Razor17019
I would say the heads and helmets are too big for the 1/18 figs.
Posted: Thu Feb 22, 2007 3:43 pm
by jeffrowse
At 6"-7" a figure, these are between half as big again to nearly twice the size of the 1/18th figures...
Posted: Fri Feb 23, 2007 4:03 am
by blaster_e11
1/18 figs are 3"3/4 high so this won't work
FRENCH & the metric system !
Posted: Fri Feb 23, 2007 7:40 am
by supersonicfifi
I am french & the metric system is the only one i know !
thanx for your help !!!!
Philippe
Posted: Fri Feb 23, 2007 8:39 am
by blaster_e11
salut philippe
si t'as besoin d'un coup de main avec les échelles US n'hésites pas
Re: FRENCH & the metric system !
Posted: Sat Feb 24, 2007 11:09 am
by jeffrowse
supersonicfifi wrote:I am french & the metric system is the only one i know !
thanx for your help !!!!
Philippe
Oh well, not everyone can be English, I s'pose. C'est la vie
6 inches <> 15cm
7 " <> 18cm
3.3/4 inches <> 10cm
Using a modern BBI infantryman as a guide, his head is about 13mm high. The MacFarlane figure would be about 20mm, or slightly bigger. Is this more helpful?
About the only practical use for these in a 1/18th "display" I can think of would be to stick a whole one at the front, to make the scene look a bit bigger front-to-back than it is, by 'forced persepctive'...