Love to tweak toys and models? Add features and small details? This forum is for you!
-
MightyMustang
- Officer - Lt. Colonel
- Posts: 1089
- Joined: Tue Nov 30, 2004 12:20 pm
- Location: Saint Paul, MN
Post
by MightyMustang » Wed Dec 13, 2006 11:25 pm
I got today the new tool Mustang Ridge Runner III. So far I've updated the cockpit and a few other odds and ends that 21st left out but for the life of me I dont know how to fix those damn bent prop blades!
I read that some of you on here fixed them but I cant remember how you guys did it. So for you guys that did fix the "bent blades" please let me know how you did it because they bother me big time. It sucks that 21st let this slip by because the new tool Mustangs are very nice. Hopefully they correct the problem with the 4-For Victory Mustangs because if they dont then I will be a very upset Ace!.
So if any of you can help me with how to fix the bent prop blades I sure would appreciate it.
Thanks guys.
MM
"You dont know the power of the darkside, it is your destiny" Lord Vader.
-
digger
- Officer - Brigadier General
- Posts: 4009
- Joined: Sat Oct 16, 2004 2:51 pm
-
Contact:
Post
by digger » Wed Dec 13, 2006 11:42 pm
I know some guys tried to heat them but didn't you say you replaced the blades on your Petie the 2d somehow? I guess you need a spare AC to pull that off. Without an extra bird I don't know what the trick would be.
-
MightyMustang
- Officer - Lt. Colonel
- Posts: 1089
- Joined: Tue Nov 30, 2004 12:20 pm
- Location: Saint Paul, MN
Post
by MightyMustang » Wed Dec 13, 2006 11:44 pm
digger wrote:I know some guys tried to heat them but didn't you say you replaced the blades on your Petie the 2d somehow? I guess you need a spare AC to pull that off. Without an extra bird I don't know what the trick would be.
Hey digger,
I did replace the prop on Petie but at the time I had a spare Mustang so I was able to scavenge the prop from it. But no luck this time around.
"You dont know the power of the darkside, it is your destiny" Lord Vader.