Page 1 of 1
Forces of Valor custom figure
Posted: Wed Dec 12, 2012 12:18 pm
by MUDHEN336
I am trying to make a custom german figure using a forces of valor upper torso with a 21st century lower torso. However the hole in the upper torso is way too big for the peg in the lower torso. Are there any quick remedies for this?
Thanks for any help!
Re: Forces of Valor custom figure
Posted: Wed Dec 12, 2012 1:13 pm
by granch
You could try to find a plastic pearl from a toy jewelry collar, same diameter as the torso hole (meaning slightly larger), make the hole for the thread through it slowly larger with bits or a needle file until you reach the diameter of the peg. Much better if you can make the hole larger at one end of the pearl to hold the peg.
Re: Forces of Valor custom figure
Posted: Wed Dec 12, 2012 1:47 pm
by tmanthegreat
Trim the peg and glue it all together - or get the Dragon 1:35 tankers, which work pretty well with the FOV vehicles.
Re: Forces of Valor custom figure
Posted: Sun Dec 16, 2012 2:50 am
by Fritzkrieg
Use the rubber tubbing, that they use in th the insides of squirt guns. I have made dozens of customs using this method.