Page 1 of 1
How to for modern armor
Posted: Fri Dec 03, 2010 7:32 pm
by NHoggard12
Maybe some of you guys have done it before, but how do you make ID panels for modern armor?
Looking to add some for 1/32 armor; i think it has been done in 1/18
thanks
Re: How to for modern armor
Posted: Sat Dec 04, 2010 10:13 am
by Ruger
Talk to Picklehaube, he made some up. If he needs a minimum order, I'll pick some up also.
MV
Re: How to for modern armor
Posted: Sat Dec 04, 2010 10:31 am
by NHoggard12
ok, I thought a board member put some together.
Are these 1/18?
I guess you can cut them down, but I not really sure what they look like--not really a modern armor guy.
Re: How to for modern armor
Posted: Sat Dec 04, 2010 2:40 pm
by pickelhaube
NHoggard12 wrote:ok, I thought a board member put some together.
Are these 1/18?
I guess you can cut them down, but I not really sure what they look like--not really a modern armor guy.
I made the CIP in 1/18 scale and 1/32 scale.
Go to page 2
viewtopic.php?f=3&t=16309&start=25
I have the plain with louvers and custom HUMVEE CIP panels as well.
Here are some being used on a 1/18 Abrams
Re: How to for modern armor
Posted: Sat Dec 04, 2010 3:05 pm
by NHoggard12
it was a while ago.
Ok, i think i just need the plain--fitting them to the front of the 1/32 abrams (thought i would try the challenger 2 as well).