Small Scale Military Headquarters

a simple mod to lower the gear and still be able to show it retracted

Nice repair. Thats one thing with almost all of these planes those stiff landing gear.

Hey mikeyt nice to see the undercart doors in the right position...can you tell us how you did it?

Studly wrote:Hey mikeyt nice to see the undercart doors in the right position...can you tell us how you did it?

how i did this is i cut a section out of the gear legs .i drilled the gear legs and installed a pin and brass tube the gear sits closer to the wing and the door covers half the wheel you[/UR[URL=http://entertainment.webshots.com/photo/2988008880105162229JOiYda]L]the gear can still retract just slide the leg down and close the doors before and affter pics

Nice mod, mikeyt.

Looks far better.

Just don't have the tools,or probably the skill anymore,to attempt this myself.

Looks way better. Do they still retract into the wing properly now that they are shorter? I might have to do this to mine!

tko211 wrote:Looks way better. Do they still retract into the wing properly now that they are shorter? I might have to do this to mine!

yes still will retract or remove and close up the doors your choice

So just to clarify. Do you have to remove a portion of the main landing gear to retract and close the doors up (now that the gear is essentially shorter). Or do the shorter gears sill allow you the clearance to fit the wheel inside the wheel well.

tko211 wrote:So just to clarify. Do you have to remove a portion of the main landing gear to retract and close the doors up (now that the gear is essentially shorter). Or do the shorter gears sill allow you the clearance to fit the wheel inside the wheel well.

you can pull the gear legs back to the orginal size and close the doors or pull them off and close the doors the shorter gears will not retract you have to remove or slide them down

right side pulled out to retract and close doors left side not pulled out doors will not close. a 3/4in section was cut out of the gear leg