Small Scale Military Headquarters

Posted: **Sun May 17, 2009 7:30 pm**

I picked up an Alumilite casting kit at Hobby Lobby not too long ago.
The first two things I wanted to do were fallschirmjager helmets and us 105 HEAT shells for my M7.
These are my best results out of three atempts so far...

Posted: **Sun May 17, 2009 9:32 pm**

easy?

plzzz do tutorial on the basics

Posted: **Mon May 18, 2009 8:08 pm**

easy, pleasey,... Japanesey.

http://www.alumilite.com/HowTos/SplitGloveMold.cfm

Posted: **Mon May 18, 2009 8:21 pm**

I got some of their black resin. it is good resin but hard to use. Because of the opequeness of the resin you can't see air bubbles and brush them out. I got about 1 out of 3 pours.

Posted: **Wed May 20, 2009 7:52 pm**

I too have used their Black resin, Pickel is right it's a little hard to use,