Small Scale Military Headquarters

recieved the lens this weekend thx

PM sent.


Steve

I sanded and drilled out the tip of the AIM-9 to accept an MV lens, (light lenses for model trains) which will now serve as the "seeker head" for the missle. This will look more realistic than just painting the tip.


Steve

These are the MV lenses that I'm using for the seeker heads. I had these in my stash box. I use these ALOT on my 1/48th model for landing lights but, sadly these are no longer available.


Steve

Slowly getting all the pieces together for the "Bombcat" upgrade, thanks Janos ! Still lots to do but, things are coming along.


Steve

Next up, modifying the aft end fuselage fairings. The B/D's had a more squared fairing than the rounded ones found on the A models. Still throwing around ideas on how to tackle this ........


Steve

did you get all 4 bombs pizza guy made the holders for me so my b/k will carry all 4 bombs.hoping to find another set up for the spot cat missed out on the last set on ebay

Someone ( who shall remain anonymous but, I can't thank them enough ) hooked me up big time !! They were willing to part with their Black Knight's bombs, pylons, Phoenix pallets and, LANTIRN pod. The bombs will require a little detail work and some paint and they'll be good to go. Maybe a little mod on the LANTIRN pod as well, we'll see.
I have a good friend of mine who is working on something special for me for the Cat. He is casting a few parts and we'll see how they come out. Once I get mine back from him, I'll post some photos. If there is enough interest in them, from you guys, he might consider producing / selling them. Stay tuned.


Steve

sounds good can t waint to see what you are up to

This shot shows the aft end fuselage fairings after being reworked. What a difference and now it looks like a B model should. Have to get some primer on this area and check for any imperfections.

Steve

Another view of the reworked area.


Steve

I added some .020" sheet plastic to the inside edge of the tails. This gives the proper 5 degree outward cant that the Tomcat tails should have.


Steve

Work on the big Cat has been slow lately, dealing with family issues. I'm getting parts ready for primer. I kept looking at the chin pod and wasn't really happy with it's plain look so, I deceided to add some fastener details. This shot is a BEFORE one and the second set of photos are AFTER adding the details. I am looking for feedback on this so, please comment. I used a #73 drill bit. I didn't want to go too small because primer and painting would have filled them in. I tried to go off of what was already on the jet from the factory. Do they look too large ?? I figured by the time I primed they would get filled in a little and become less obvious.
Now the issue becomes, where do I stop on the jet with this detail. This is a problem I have, I tend to try and do too much to my projects and I get frustrated and they don't get finished. Comments and suggestions are welcomed, thanks guys.


Steve

BEFORE ......

AFTER .....

I had to add some .010" sheet plastic to the tails, where they meet the forward fairings. I want to paint the tails seperately from the jet, to avoid that dry overspray area I'd get between the tails during painting.

Everything sanded down and blended in. This will allow me tp paint the tails seperately and have a seamless fit when they are attached.

Up next, adding the air intake for the fuel vent on the left vertical tail's forward fairing.


Steve

This looks awesome, really like what you did with the tails and the 5% cant and the redesign of the back end GE engine farrings. I like the detail on the TCS pod. Keep up the great work, thank you for sharing it.

Air intake for the fuel vent sketched with pencil, here goes nothing.