Page 1 of 1
Need info on this truck
Posted: Thu Sep 28, 2006 6:14 pm
by Moth
Does anyone have any information on this Bedford truck?
http://www.missing-lynx.com/gallery/britain/migbed.htm
I need the dimentions, and a photo of the rear. (Of real one, not model
)
Thanks for your help!
Posted: Thu Sep 28, 2006 8:19 pm
by lsc1002
I don't have photo but the dimensions are as follows
Length: 4.38m or 14ft 4.5in
Width: 1.99m or 6ft 6in
Height: 2.29m or 7ft 6in
Wheelbase 2.51m or 8ft 3in
Encyclopedia of Weapons of WWII
I hope this helped
Posted: Thu Sep 28, 2006 8:26 pm
by Moth
It helps very much, Thanks!
Do you know what engine it used?
And do you have a photo of the engine?
Also, was it RWD or 4WD?
Posted: Thu Sep 28, 2006 8:52 pm
by lsc1002
the power plant for the 4x2 bedford was 6-cylinder OHV 3.5 litre.
I just noticed that are two heights:
2.29m or 7ft 6in with GS tilt and
1.93m or 6ft 4in with GS tilt.
I have no idea what GS tilt is but I thought you might know and want the info.
I do not have a picture of the engine but I do have a picture of the truck I can try and scan it and email it to you if you want it for ref. It would not be until this weekend though.
That is a cool little truck are you planning on make one?
Posted: Thu Sep 28, 2006 8:58 pm
by Moth
I think GS Tilt is another saying for "Rake", as in the back sits higher than the front, but im not sure.
Well, you guessed it, im going to try to make one, if I can figure out how to make the wheels. The front wheels look very similar to the Hanomag's wheels, but im not going to rip them off mine.
I have never tryed to built anything 1/18 scale from scratch though.