Dragon Armour Leopard 2-A5 error(s?)

ltcbj · Post by **ltcbj** » Fri May 13, 2005 8:14 am

My Leopard has the barrel tip twisted 90* (facing) to the left. Do they all come this way? and, There doesn't seem to be anywhere (obvious) for the single aa- machine gun to be placed.

Jorg · Post by **Jorg** » Fri May 13, 2005 1:28 pm

I'm not sure what you mean by twisted. If you mean the muzzle reference sensor is on the the side, rather than the top, this is normal for a Leopard.

The MG3 mounts in one of the holes on the hatch on your right (as you face the front of the tank).

ltcbj · Post by **ltcbj** » Sun May 15, 2005 6:29 am

Thank you Jorg: I had no idea that was standard. I thought it was made askew. Learn something new everyday.... On the other hand I still can't find any holes in the loader's hatch. there is a spot that I see would be meant for a mg mount, but it isn't deep enough to fit the mg into, at least on my copy.

hawkonevoodoo · Post by **hawkonevoodoo** » Fri Jun 03, 2005 2:38 pm

ltcbj wrote:Thank you Jorg: I had no idea that was standard. I thought it was made askew. Learn something new everyday.... On the other hand I still can't find any holes in the loader's hatch. there is a spot that I see would be meant for a mg mount, but it isn't deep enough to fit the mg into, at least on my copy.

There should have been a little piece of paper that came with the gun. It shows a small pin hole on the front ring of the left hatch. This is where the gun goes in.