Posted: Thu Mar 15, 2007 10:39 am
On the 1st releases, the prop blades were bent inwards slightly, but it was very noticable..
Small Scale Military Headquarters
Your Headquarters for Small Scale Military Enthusiasts!
https://www.warbird-photos.com/gpxd/
P-51 Problem
https://www.warbird-photos.com/gpxd/viewtopic.php?f=1&t=7586
Page 1 of 1
Posted: Thu Mar 15, 2007 3:12 pm
Is there a way of correcting the bent angle of these first edition propellers
Posted: Thu Mar 15, 2007 4:08 pm
Many have tried, but I don't think anyone has done it sucessfully..mountian-man wrote:Is there a way of correcting the bent angle of these first edition propellers
Posted: Fri Mar 16, 2007 6:08 am
hworth18 wrote:Many have tried, but I don't think anyone has done it sucessfully..mountian-man wrote:Is there a way of correcting the bent angle of these first edition propellers
hworth18 I fixed mine on Ridge Runner 3 sucessfully buddy. All I did was cut the prop blades off and re-positioned them correctly. So it can be done.
Posted: Fri Mar 16, 2007 10:50 am
Congrats!!! I didn't know anyone was successful...MightyMustang wrote:hworth18 wrote: Many have tried, but I don't think anyone has done it sucessfully..
hworth18 I fixed mine on Ridge Runner 3 sucessfully buddy. All I did was cut the prop blades off and re-positioned them correctly. So it can be done.
Posted: Fri Mar 16, 2007 11:25 am
I did it as well, but I didn't cut the blades completely off. Carefully I cut them a little more then half way and then pulled them slightly forward until they just began to break. You need to do this gently. When the prop is in the right position I filled the small gap that was created with gap filling super glue like Zap. When dried the prop was as strong as ever and properly aligned as well.