FW 190 Gear Repair
Posted: Sat Jan 22, 2011 6:11 pm
I can't blame my kids for this one
. The cats on the other hand are the likely suspects. In the end I had to repair the main gear as one tab on each one failed after hitting the floor
. It is my opinion that the tabs are weak at best for such a big plane. Anyway here is the repair job.
I used 20 gauge sheet metel and welded a 3/32nd nail to it. The 3/32nd nail will be the new tabs.

Then drilled a 5/64 hole through the sheet metal and into the gear.

Then roughed up a 5/64 nail, added super glue, and press in.

All that was left was to remove the closest two screws in the wings near the main gear. Carefully pry apart the wing and sneak in the repaired gear.

All done, and this is all you can see with the gear up.

I'll add a little touch up paint to make this repair almost impossible to notice.
Now if I could just find the tail wheel
BLACKSNAKES


I used 20 gauge sheet metel and welded a 3/32nd nail to it. The 3/32nd nail will be the new tabs.

Then drilled a 5/64 hole through the sheet metal and into the gear.

Then roughed up a 5/64 nail, added super glue, and press in.

All that was left was to remove the closest two screws in the wings near the main gear. Carefully pry apart the wing and sneak in the repaired gear.

All done, and this is all you can see with the gear up.

I'll add a little touch up paint to make this repair almost impossible to notice.
Now if I could just find the tail wheel

BLACKSNAKES