Page 1 of 1
1/18 Cromwell?
Posted: Tue Oct 27, 2009 2:54 pm
by bananapirate
Since the Dragon Michael Wittman display already includes an extremely well made turret with opening hatches and chunk of upper hull, it's almost halfway there
unless we see one in 1/16 RC someday
Posted: Tue Oct 27, 2009 2:58 pm
by Stug45
I think its bigger then 1/18
Posted: Tue Oct 27, 2009 3:15 pm
by bananapirate
Stug45 wrote:I think its bigger then 1/18
it says 1/18 on the box and it's about the size of a Tiger I turret. the figure is 1/18 too
Posted: Tue Oct 27, 2009 3:19 pm
by Stug45
I think aferguson measured it.
Posted: Tue Oct 27, 2009 4:23 pm
by aferguson
yes very big. The turret is 1/16, apparently copied from some resin kit made years ago. Looks very large...plus it's only half a turret, there's no other side.
Posted: Tue Oct 27, 2009 4:47 pm
by ostketten
plus it's only half a turret, there's no other side.
Yeah, and it's got a freakin' hole in the good side...
I almost bought one of these things once at a really good price, not for the turret but for the Wittman figure, which would have gone well with my 1/16 Kingtiger.
Posted: Tue Oct 27, 2009 8:20 pm
by bananapirate
ostketten wrote:plus it's only half a turret, there's no other side.
Yeah, and it's got a freakin' hole in the good side...
I almost bought one of these things once at a really good price, not for the turret but for the Wittman figure, which would have gone well with my 1/16 Kingtiger.
Ha yeah, I bought it for the same reason. The figure is sitting on my King tiger right now
that's really too bad if it's too big..