Page 1 of 1
How many would be interested in the Stryker?
Posted: Thu Jul 30, 2009 1:41 pm
by trex0770
How many people here would want a 1/18 scale Stryker and what would you be willing to pay? There's a strong possibility it will be done if enough people are interested (unlike the F-5 thread).
Considering other projects like the Wirbelwind (done by Pickelhaube), etc., what would be a reasonable price you'd be willing to pay?
Posted: Thu Jul 30, 2009 1:49 pm
by cornbreadfred
I'd still take an F-5.
Posted: Thu Jul 30, 2009 2:01 pm
by exether_mega
a Striker would be a nice piece in any collection. I would gladly pay 70 to 80$ for one.
phil
Stryker
Posted: Thu Jul 30, 2009 2:30 pm
by Rylau
I'd go $75 if it was up to 21st standards in detailing. Bob
Posted: Thu Jul 30, 2009 3:53 pm
by popeye357
50-70 clams
Posted: Thu Jul 30, 2009 4:28 pm
by tmanthegreat
The same as what the others said with the $60-$80 range.
Posted: Thu Jul 30, 2009 6:02 pm
by CW4USARMY
I'd definitely take a couple at the 70.00 range.
Posted: Thu Jul 30, 2009 6:12 pm
by YT
Sounds good, of course price is dependent on detail.
Posted: Fri Jul 31, 2009 12:53 am
by Black_Dragon_One
[quote="YT"]Sounds good, of course price is dependent on detail.[/quoteut
ditto.. i agree with the guys but i know better the work that goes making these... so i do not think it will happen..
Posted: Fri Jul 31, 2009 7:29 am
by Birddog
I'm in too......
Posted: Fri Jul 31, 2009 10:00 pm
by DocTodd
I have some interest, but as above depends on detail and price $75 would be OK.
T
Posted: Fri Jul 31, 2009 11:09 pm
by Black_Dragon_One
Black_Dragon_One wrote:YT wrote:Sounds good, of course price is dependent on detail.[/quoteut
ditto.. i agree with the guys but i know better the work that goes making these... so i do not think it will happen..
can you make it happen for $100.
Re: How many would be interested in the Stryker?
Posted: Fri Jul 31, 2009 11:49 pm
by coreystinson
trex0770 wrote:How many people here would want a 1/18 scale Stryker and what would you be willing to pay?
I'm interested and would pay in the $80+ range if it was 21st Century/Elite Force quality, had lots of nice detailing, etc.
If Forces of Valor released on in 1:18 scale that looked like that picture they circulated last year, I'd be happy.
Posted: Sat Aug 01, 2009 4:10 am
by gburch
I'd definitely be in on a Stryker. Most definitely.
I'll have to build a bigger modern diorama, though ....
Posted: Sat Aug 01, 2009 6:10 am
by flpickupman
LAV variants would be a good route to go as well. The mortar variant is relatively simple, as is the logistics version. Heck, you could probably swing a C-squared too.