Small Scale Military Headquarters

Hey everyone,
I'm trying to get my BBi Pave Hawk apart to begin doing some custom work on it. I've removed the plugs that cover the screw holes and removed the screws. That is about as far as i can get, besides the obvious removal of the tail, doors, etc.

The piece is evidently well glued. I'm currently running a knife along the seams in order to try and force it apart, but I'm not having a lot of luck. The posts that hold the screws in place are probably glued together as well, which makes things difficult.

I've seen folks here on the forum with theirs completely disassembled and I'm wondering if there are any tricks or tips you could share to help me out?
Thanks everyone.

Trolling over here too, i see.

Whenever i see a forum, i just have to troll it!

So what kind of mods do ya have in mind?

I'm wanting to do an entire interior mod first and build from the inside out. Cockpit, crew chief, and troop areas would all be modified. After that i want to begin modifying the helicopter to look more "real." Add a working flap in the rear, antennas, plum detectors, etc etc. A full build out.
I think my eventual goal is to modify it into the MH-60L model.
Unfortunately getting it open is the first task at hand.

You, sir, are a man of ambition.

One of the very best modders around is Mig29 and he has done extensive mods to the Pavehawk to make it a Seahawk including the interior. I haven't seen him around much lately, but you might want to PM him and see if he can help.

Awesome, thanks for the advice. I will see if i can get a PM out of him.

I managed to get it split today with a little determination. Thanks all.

This thread is trolling without PICS!