Page 1 of 1
Question for the RC memebers.
Posted: Mon Nov 17, 2008 12:20 pm
by hotrodrock
Is the bottom half of the Heng Long Panther the same as the Heng Long Tiger? There is an RC site that sells custom painted top halves of the Tiger at a decent price. I have one of HL's god awful Panthers and would like to just swap out the tops if the bottoms are the same. There is a difference in the rear piece that has the exhaust but I can get around that. Not worried about the innards, will use it as a static model only.
Posted: Mon Nov 17, 2008 2:49 pm
by smittyrob64
I don't have a HL pantiger, but I'm pretty sure the lower hulls are the same. The rear exhaust area is a plate that slides out of 2 slots on each side so if you got the rear plate from a tiger it should just slide into the pantigers lower hull.
*%+!#^@&$
Posted: Mon Nov 17, 2008 6:41 pm
by MG-42
*%+!#^@&$
Re: *%+!#^@&$
Posted: Mon Nov 17, 2008 9:49 pm
by hotrodrock
MG-42 wrote:*%+!#^@&$
Are you sure? I was thinking more along the lines of (*&^%$!