New flying tiger p40 question

V2 MAN · Post by **V2 MAN** » Thu May 08, 2008 6:32 pm

Last week i picked up one of the new flying tiger p40's at my local tru. Anyway i put the plane together and noticed that on the aircraft that there was no symbol for the plane on the blue circle. I looked in the box and found a sheet with 4 of the symbols. Anyway i was wondering if anyone could tell me how to put these on? I tried to peal them like stickers but their not. So if anyone could help me id really appreciate it so i can get this bird diplayed

GooglyDoogly · Post by **GooglyDoogly** » Thu May 08, 2008 6:55 pm

Those are water-slide decals. Don't peel them!!!!

Cut out each markings individually, then soak them in water for 10-15 seconds, until you feel the decal slide off the paper backing. Then just slide the decal into place.

tmanthegreat · Post by **tmanthegreat** » Thu May 08, 2008 7:07 pm

That, and brush a little MicroSol solution onto the decal to help it blend in smoothly with panel lines and seams on the wing.

V2 MAN · Post by **V2 MAN** » Fri May 09, 2008 1:33 pm

THANKS GUYS

Now i can put them on and display this wonderful aircraft