$10 (my cost) plus shipping. Note these are inexpensive because they are printed on a prototype type printer versus Shapeways where they are $50. There is some stepping as a result. Stepping is a 3d printing defect in the form of lines that have to be filled with primer. Zoom in and you can see the lines.
And yes, that little bit of material at the end of the MG shroud will not be there. I don't know where that came from and only noticed it after the photo.
![Image](http://i.imgur.com/dJ0Nmur.jpg)
Replaces this beast:
![Image](http://i.imgur.com/sj0gOPC.gif)