I have been checking some injection moulding companies to possibly do this project. Just for laughs.
Well it would cost about $50,000 on the low side to make molds for this. My area only.
The sales person told me. If I wanted to make about a 8 " ruler. The molds will cost aprx. $7,500
If it were a 16 " ruler the cost would be $10,000.
So with all of the componds curves, panel lines and what not $50,000 - $100,00 will not be out of the question.
So this will be ruled out. No pun intended.
Last nite was a semi bust. The guys I talked to think that 1/32 scale is big.
Some of them never heard of 1/18 scale. So , I do have some painting skills. I just do not like to do it. So I guess I will have to bite the bullet. I have some other feelers out for painters and I feel good that I can get this worked out.
What I can do is offer the A-10 painted or unpainted. So you all can have the best of both worlds.
S-1 WILL BE THE LIGHT GRAY TIGER SHARK MOUTH OR WARTHOG.
I can do this in either template paint or decals format . Of course with correct squadron numbers.
So as it goes I am about 85 % sure this will be a reality
In the past I have made some items and had dismal sales on them. They were not even worth making because some of the guys who wanted them vanished. That is the reason I will be taken pre-deposits BEFORE I get started on this. I will be in the whole for at least $1,000 - $1,500 for R and D.
So est. cost will be:
$250- $350 unpainted
$ 350- $550 painted. S-1
These prices are a guess. I hope to not exceed them . But with fingers crossed I will try to get lower.
That being said when I am ready to start. I will need 10 deposits to get started.
I will also take lay - aways. 1/3 down will get you in and we can work out a payment plan.
I know some of you need to see the finished product before you anti up. But the way things are going at this time I can not come out of pocket on this project. And I need reassurance of sales on this before I start on such a LARGE PROJECT.
So there it is guys.
Let me know who will be in on this . I need to know because I need to order supplies and start getting my ducks in a row. You can either post , PM or contact me via e-mail. Here is my e-mail:
[email protected]
Thanks,
Matthew