Cast Copies Available

[pickelhaube]

Hey Guys I have a few molds made of 1/18th scale parts and cam make more if needed .

What I have made ( molds ) now

21st P-51 stabs . left and right
BBI Zero stabs . Left right
Huey rear rotor with wire embedded
Proper Stuka replacement prop
M-113 copula hatch cover

once located I will add more.

[normandy]

Hey Pickel, Did you ever make molds of helmets or visor (officer) hats ?
I was looking for FOV German helmet without the camo cover.


21st Luftwaffe Major Von Schnitzel visor hat.


21st Sgt. Max Rode SS visor without headphones.


I've tried but with very limited success. You Da Man when it comes to mold making and casting!

[pickelhaube]

I do not think I have any originals.

If you got them I can copy them.

[normandy]

Dang that was fast, I was still typing......

I've got to go out right now but if your home today I'll give you a call!
Thanks,
Normandy.

[norman888]

How about a FW190A spinner and prop? But mainly the spinner!

[pickelhaube]

How about a FW190A spinner and prop? But mainly the spinner!

OK, I have actually made one years ago but have never copied it.

The Fw-190 proper prop will had once Merit releases their 190 .

OK so maybe I should make one ....again.

[Razor17019]

PH,
What about a P-51 prop?
And is it easy to remove a broken prop from a plane?
Razor

[pickelhaube]

PH,
What about a P-51 prop?
And is it easy to remove a broken prop from a plane?
Razor

I could make a replacement prop for the 51.

Hopefully not bent.

Usally props are hard to get off because the screw holding them inside the fuselage is sealed tight when they glue the fuselage halves together .

I have never tried to take a 51 fuse apart to tell you the truth.