Can anyone give me instructions on how to take apart the fusalage of the F-4 without damaging any of the screw hole covers?
I'm trying to remove the intakes to add tamya upgrade intakes.
Help NEEDED On BBi F-4.
-
The_Helicopter_Pilot
- Officer - Major
- Posts: 974
- Joined: Sat Sep 01, 2012 3:27 am
- Location: Cordell, Oklahoma
- Contact:
Help NEEDED On BBi F-4.
A helicopter does not want to fly, it just vibrates so much that the ground rejects it
-
tmanthegreat
- Officer - Brigadier General
- Posts: 11238
- Joined: Tue Oct 05, 2004 7:38 pm
- Location: Central California
-
The_Helicopter_Pilot
- Officer - Major
- Posts: 974
- Joined: Sat Sep 01, 2012 3:27 am
- Location: Cordell, Oklahoma
- Contact:
Re: Help NEEDED On BBi F-4.
I contacted bbi, they said each cover is glued in, so... In a way I did do that, I'll just cast some lead covers for replacements after I get the upgrade installed..
A helicopter does not want to fly, it just vibrates so much that the ground rejects it
-
Mad Sam
- Officer - 2nd Lieutenant
- Posts: 295
- Joined: Fri Oct 22, 2010 8:52 am
- Location: Southwest England
Re: Help NEEDED On BBi F-4.
The tmanthegreat method has a far higher comedy factor, and if you look closely at his picture, the screw covers have in fact come off in one piece - they're just to the right of the main explosion, and about to go into orbit....