Improved Gun for the 1/6th RC Ultimate Soldier M5 Stuart
Posted: Sat Jan 28, 2017 12:44 pm
I received a request to upscale my 1:16/1:18 M5A1 turret for the 21st Century / Ultimate Soldier 1:6th scale Remote Control M5. It turned out well. Reply here if you have a big RC M5 in need of an accurate gun to replace the nerf dart one it comes with.
$10 (my cost) plus shipping. Note these are inexpensive because they are printed on a prototype type printer versus Shapeways where they are $50. There is some stepping as a result. Stepping is a 3d printing defect in the form of lines that have to be filled with primer. Zoom in and you can see the lines.
And yes, that little bit of material at the end of the MG shroud will not be there. I don't know where that came from and only noticed it after the photo.
Replaces this beast:
$10 (my cost) plus shipping. Note these are inexpensive because they are printed on a prototype type printer versus Shapeways where they are $50. There is some stepping as a result. Stepping is a 3d printing defect in the form of lines that have to be filled with primer. Zoom in and you can see the lines.
And yes, that little bit of material at the end of the MG shroud will not be there. I don't know where that came from and only noticed it after the photo.
Replaces this beast: